Home » Description » Actuators » Muscles »


A pneumatic artificial muscle is, in essence, a membrane that will expand radially and contract axially when inflated, while generating high pulling forces along the longitudinal axis. Different designs have been developed. The best known is the so called McKibben muscle (example is the Air Muscle of the Schadow Robot Company). This muscle contains a rubber tube which will expand when inflated, while a surrounding netting transfers tension. Hysteresis, due to dry friction between the netting and the rubber tube, makes control of such a device rather complicated. Typical of this type of muscles is a threshold level of pressure before any action can take place. The main goal of the new design was to avoid both friction and hysteresis, thus making control easier while avoiding the threshold. This was achieved by arranging the membrane into radially laid out folds that can unfurl free of radial stress when inflated. The membrane's stiff longitudinal fibres transfer tension. The inflated and deflated state of the Pleated Pneumatic Artificial Muscle are illustrated below.

Different contractions levels of the artificial muscles

These artificial muscles have specific properties that are of special interest in the field of legged robots:

The generated force is highly non-linear and proportional to the applied gauge pressure in the muscle. At a pressure of 300 kPa the force can be as high as 4000N for a device with initial length of 10cm, weighing only 100g.
Pneumatic artificial muscles only generate force when they shorten. To have a bi-directional working joint one has to couple two muscles antagonistically. At each joint the muscles are attached in a leverage mechanism by pulling rods. The points of attachment are essential in the design since they determine torque characteristics.

In an antagonistic setup without external load, position will be determined by the ratio of pressures in both muscles. In previous work (Daerden) a revolute joint was build for rotations between -30° and 30°. A step response from 0° to 10° was achieved with end error within 0.1° and overshoot less than 1° making use of proportional valves to control both pressures.

The artificial muscle is inherently compliant due to gas compressibility and the dropping force-contraction curve. In an antagonistic setup compliance is determined by the sum of the pressures in both muscles, therefore both position and stiffness can be controlled.

Hopping Mechanism with Knee Actuated

To investigate this, a hopping mechanism (see picture above) composed of a lower leg, upper leg, hip and body sliding along a guide shaft was built. Only the knee is actuated by a pair of artificial muscles. During experiments the leg was dropped from a fixed height while both muscles were kept closed. During stance, the leg will bend and stretch the extensor muscle. In this muscle, pressure and forces will increase as it extends, which implies that the extensor muscle stores motion energy that will be released as soon as the leg starts straightening. During these tests energy recuperation of up to 30% is registered.

More information on this topic can be found in (Verrelst e.a. clawar 2000)

(movie 23Mb Avi)

Vrije Universiteit Brussel,    Faculty of Applied Sciences,     Department of Mechanical Engineering
Pleinlaan 2,    1050 Brussels,    tel. 32-2-629.28.06,    fax 32-2-629.28.65
© Nico Smets - All Rigths Reserved